Tattu Plus2.0 18000mAh 6S1P 22.2V 15C Smart Lipo Battery with AS150+XT150 plug will give your UAV the enough power for long time to fly. The Version 2.0 is the updated version of Tattu Plus series. 7 LED lights on the battery make it convenient for your use. It is easy to check the service life of the pack. Storage mode will be auto-activated.
Specifications:
- Minimum Capacity: 18000mAh
- Configuration: 6S1P / 22.2V / 6Cell
- Discharge Rate: 15C
- Max Burst discharge Rate: 30C
- Net Weight(±20g): 2270g
- Dimensions: 205.5mm Length x 94.2mm Width x 79.5mm Height
- Discharge Plug: AS150+XT150 plug
- Charge Plug: XT90
Features:
- Overheat protection
- Low temperature protection
- Over voltage protection
- Over current protection
- Intelligent Storage:
- Normal temperature range storage
- Above normal temperature storage 60-70℃ (158°F –176°F)
- Hot conditions storage 70-80℃ (158°F – 176°F)
- Local after-sales service(located in Düsseldorf , Germany)
Function Comparison between Tattu Plus and Tattu Plus 2.0
|
Feature
|
Tattu Plus
|
Tattu Plus 2.0
|
|
Fuel Gauge
|
YES |
Yes, the fuel gauge is run by a very accurate coulomb meter and impedance tracking circuit. This makes the fuel gauge display very precise.
|
|
Self Balance in storage mode
|
YES |
Yes, the pack will self balance the individual cells depending on the SOC(State of charge) difference during storage mode
|
|
Discharge Low voltage warning
|
LED Flash Warning
|
Audible warning system
|
|
Discharge over temperature warning
|
LED Flash Warning
|
Audible warning system
|
|
Cycle life indicator
|
NO |
YES |
|
Defective Pack Warning
|
NO |
if you click the pack button and the fuel gauge shows red L.E.D.s, it is time to replace this pack. |
|
Battery low voltage warning
|
NO |
Yes, if you click the button and the fuel gauge shows yellow L.E.D.s the pack voltage is low and you need to recharge.
|
|
Battery storage indicator
|
NO |
Yes, The storage is turned on if you click the button and the fuel gauge shows white L.E.D.s the pack is in storage mode.
|
|
Advanced charging protection
|
NO |
Yes, if the pack individual cell voltage is too low when charging is started,the BMS will limit the incoming charge current to battery until the voltage is correct, then accept full supplied charge current
|
|
Voltage Overcharge Protection
|
NO
|
Yes, the overcharge protection circuit will activate when any cell voltage exceeds the factory set failsafe values.
|
|
Charging over current protection
|
NO
|
Yes, charging over current protection circuit will be activated when charging current reaches factory set failsafe values. The protection circuit will remain active until charger is disconnected.
|
|
Charging short circuit protection
|
NO
|
Yes, the protection circuit will cut off charging when it detects that the current reaches the factory set short-circuit protection limit. When protection is triggered all FETs will be turned off.
|
|
High Temperature Charge Protection
|
NO
|
Yes, if the pack temperature exceeds factory set values It will not charge. When the pack is back in the correct temperature range it will charge normally
|
|
Low Temperature Charge Protection
|
NO |
Yes, if the pack temperature falls below factory set values the pack will not charge. When the correct temperature is back in range the pack will charge normally.
|
|
Secondary Charge Protection
|
NPO |
Yes, Tattu Plus 2.0 has a secondary charging protection circuit. If the first level circuit has a failure, the second level of protection will cut the charging circuit off
|
|
IIC communication port
|
NO |
Yes, The IIC communication port is active. When you connect the batterypack to the computer software the IIC will allow you to read: pack voltage, individual cell voltage, rated capacity after full charge, remaining capacity, capacity percentage, cycle time, tem
|
Our services
1. Your orders will be dispatched via TNT or DPD from Germany directly. Free shipping is available for order over €69.99 within Germany. For batteries below 100WH, free shipping available when over €299.99 outside Germany.
2. Fast shipping and excellent local after-sale service guaranteed in Europe.
3. Service-priority in online shop, like the long warranty period and the lower price. We provide 6 months warranty, there would be special discount provided for orders been over 6 months.
4. Energy Density: Special adapted to each UAV type and RC car/boat/heli type. Very High according to capacity/weight. In fact we are specialists of High Power Lipo Batteries. It is our unique technology, the highest power of our battery is 100C.
The another technology is our batteries are able to be stable discharged simultaneously.
5. Low IR: Provides stable voltage until the end of your mission.
6. Safety: Gens Ace and its' partners ful fill the ISO9001, ISO14001 standards
