New generation of our market leader Strobon Navigation Lights.
Now, it's configurable for 5 different patterns.
Strobe/Blink/Heartbeat/Rotating Beacon/Solid
NEW PRODUCT!!!!
STROBON Lights are the most powerful navigation lights on the model market for years.
Now, it's configurable for 5 different patterns!
Strobe (Legendary Strobon v1 strobe effect. 3 fast flashes like xenon wing tip flash lights)
Blink (Simulates belly or tail lights. Continuous ON/OFF)
Rotating Beacon (perfect simulation of rolling beacons. ramp up/flash/ramp down/off)
Static (you can use it as landing headlights or static wing-tip lights)
It allows 2 different working modes;
RC Controlled Mode: Plug it on your RC receiver’s any channel for RC mode, then you can enable/disable it over selected servo channel.
Each Strobon counts the servo signals. So, you can plug more than one Strobon to the same RC channel to syncronize them. (check the schematic below)
Standalone Mode: Power it with directly from the battery (3.5-6v) it works on Standalone mode and works continuously.
Specifications
Supply Voltage: 3.5 - 6 volt
Current Consumption per hour @5V
Strobe: 60mA (1A when flashing)
Blink: 70mA (150ma ON)
Heartbeat: 120mA
Rolling Beacon : 170mA (1A when flashing)
Static: 140mA
Diameter: 21.5mm
Height: 6mm
Screw Holes: 1.5mm diameter & 18mm distance
Weight: 1.50 gram without wires
Wire Length: 30cm (only for "with wire" option)
PATTERN SELECTION
All you need a piece of wire or a tweezer to change the pattern.
Connect two small pads of the Strobon v2 board while it's working (it will not change the pattern when it's OFF)
It will stop working when you connect these pins and jump to next pattern when you release the connection.
That's all.
SCHEMATIC for SYNCRONIZED & RC CONTROLLED MODE
SCHEMATIC for STAND ALONE MODE
Customer Video, Thank you Fernando :)
(you can find the instructions and wiring details under the video description)